BlueWalker PowerWalker VFI 6000C LCD Instrucciones de operaciones descargar pdf (Pagina 23)

Battery mode

Description

When the input voltage is beyond the acceptable range or power failure,

UPS will backup power from battery and alarm will beep every 4 seconds.

LCD display

Bypass mode

Description

When input voltage is within acceptable range and bypass is enabled,

turn off the UPS and it will enter Bypass mode. Alarm beeps every two

minutes.

LCD display

Battery Test

Description

When UPS is in AC mode or CVCF mode, press “Test” key for more than

0.5s. Then the UPS will beep once and start “Battery Test”. The line

between I/P and inverter icons will blink to remind users. This operation

is used to check the battery status.

LCD display

Fault status

Description

When UPS has fault happened, it will display fault messages in LCD

panel.

LCD display

3-8. Fault Code

Fault event

Fault code

Icon

Fault event

Fault code

Icon

Bus start failure

None

Inverter output short

circuited

Bus over

None

Negative power fault

None

Bus under

None

Battery SCR short circuited

None

Bus unbalance

None

Inverter relay short circuited

None

Inverter soft start failure

None

Over temperature

None

High Inverter voltage

None

CPU communication failure

None

Low Inverter voltage

None

Overload

1 2 ... 18 19 20 21 22 23 24 25 26 27

Comentarios a estos manuales

Sin comentarios

BlueWalker PowerWalker VFI 6000C LCD Instrucciones de operaciones Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Sistemas De Alimentación Ininterrumpida (Sai) BlueWalker PowerWalker VFI 6000C LCD